21st of March 22nd of March
09:30-10:00 Coffee & Tea + small breakfast 08:30–09:00 Coffee & Tea
09:30-10:00 Registration 09:00–09:30 Screw for motorboat, metal replacement
_ (Hampus Johansson, Erteco Rubber and Plastics)
10:00-10:10 Welcome
_ 09:30–10:00 Moldex3D Stress and 2 way FSI, coupled structural analysis
10:10-11:00 What’s new in R14 (Venny Yang, Moldex3D) (Peer Guldbrandsen, FlowHow®)
11:00-11:30 Enhanced Warpage (VE-warpage) (Henry Huang, Moldex3D) 10:00-10:30 Support disk for Smart Digital XL, (Michel Haenel, Grundfos)
11:30-12:00 Designer BLM, Boundary Layer Meshing new features, 10:30-11:00 Coffee break
_ tips and tricks (Mads Jespersen, FlowHow®)
_ 11:00–11:30 Moldex3D Digimat-RP Solution for fiber-reinforced material
12:00–13:00 Lunch (Henry Huang, Moldex3D)
13:00-13:20 Fiber orientation benchmark (Peer Guldbrandsen, FlowHow®) 11:30-12:00 Setup Multi Component analysis, mold and part inserts and 2K
_ molding (Mads Jespersen, FlowHow®)
13:20–13:35 Short-shot vs. simulation (Brian Keith Sørensen, LEGO)
_ 12:00–13:15 Lunch
13:35-13:50 Project API (Brian Keith Sørensen, LEGO) 13:15–14:00 Future development and outlook in Moldex3D (R15)
_ (Venny Yang, Moldex3D)
13:50-14:05 Strategy on structural analysis interface
_ (Therkel Damm, Grundfos A/S 14:00–14:45 Coffee break
14:05-14:30 Warpage, parameters and results (Mads Jespersen, FlowHow®) 14:45–15:15 Co-injection and flake simulation, (Patrick Guerrier, LEGO)
_
14:30–15:10 Coffee break 15:15-15:45 Mold compensation using Moldex3D warpage results
_ (Peer Guldbrandsen, FlowHow®)
15:10-16:00 Liquidmetal Technologies, injection molding of metal
_ (Michael Wiesinger, Engel) 15:45–16:00 Goodbye
16:00-16:10 Reuse of results in another run (Mads Jespersen, FlowHow®)
16:15-16:30 Walk 1 km to Braunstein brewery
16:30-18:00 Visit local brewery Braunstein
19:30- Conference Dinner